Milled system HOH 12,5 - (materiaal & montage /m²)
The TT FLOOR Milling System is a complete, high-quality underfloor heating system in which the heating pipes are milled directly into an existing screed. This requires only minimal floor build-up, making underfloor heating easy to install in renovation projects. Thanks to its efficient heat transfer and short heat-up time, the system is particularly suitable for low-temperature heating systems such as heat pumps, where maximum heat output, fast response and even temperature distribution are required.
Our price includes:
✓ Preparation of a laying plan
✓ Supply and installation of stainless-steel manifolds
✓ Supply and installation of edge insulation
✓ Milling of the floor heating pipe channels into screed or Fermacell
✓ Supply and installation of 16 mm underfloor heating pipes
✓ Pressure testing of the circuits with air at 3 bar
✓ Preparation of an as-built plan and photographic report
Works not explicitly mentioned above are not included (including floor insulation, expansion joints, repairs or levelling of the existing floor, filling, venting and control of the installation, etc.).
The existing substrate must be suitable for milling and must be sufficiently stable, sound and free of pipes or other obstacles. Any repairs, levelling or modifications to the substrate are not included.
Options and deviations:
◇ Plastic manifold: +€1.00/m²
◇ No installation of edge insulation: -€0.50/m²
◇ Manifolds installed by the customer: -€0.40/m²
◇ Wall penetrations: +€10.00/circuit
◇ Installation of plywood support board: +€60.00/manifold
Our price includes:
✓ Preparation of a laying plan
✓ Supply and installation of stainless-steel manifolds
✓ Supply and installation of edge insulation
✓ Milling of the floor heating pipe channels into screed or Fermacell
✓ Supply and installation of 16 mm underfloor heating pipes
✓ Pressure testing of the circuits with air at 3 bar
✓ Preparation of an as-built plan and photographic report
Works not explicitly mentioned above are not included (including floor insulation, expansion joints, repairs or levelling of the existing floor, filling, venting and control of the installation, etc.).
The existing substrate must be suitable for milling and must be sufficiently stable, sound and free of pipes or other obstacles. Any repairs, levelling or modifications to the substrate are not included.
Options and deviations:
◇ Plastic manifold: +€1.00/m²
◇ No installation of edge insulation: -€0.50/m²
◇ Manifolds installed by the customer: -€0.40/m²
◇ Wall penetrations: +€10.00/circuit
◇ Installation of plywood support board: +€60.00/manifold